What is the easiest way to get ring and bangle ends to meet with no gaps ready for soldering . It seems to take me an age to get it right.
What is the easiest way to get ring and bangle ends to meet with no gaps ready for soldering . It seems to take me an age to get it right.
Last edited by Edelle; 21-02-2021 at 06:43 PM. Reason: Missed a letter out
Close them up as close as possible, run a fine sawblade through. Close it up and see if it's adequate; if not, run the saw through again.
Have a look at Andrew Berry on rings https://www.youtube.com/watch?v=xaU5acww9gc. Bangles are just a bigger version of that. Dennis.
Thanku for your reply. I do use a saw blade to cut through and I have previously watched Andrew Berry's technique which I like but I think I need to practice sawing in a straight line as I seem to veer off a bit. Probably just practice.
Bookmarks