Hi all, been trying to source the above item but so far the largest one of my supplies can manage is 10mm. Must be solid silver, not plated. If anyone knows of where I can get this etc, I'd be extremely grateful! Thank you kindly x
Hi all, been trying to source the above item but so far the largest one of my supplies can manage is 10mm. Must be solid silver, not plated. If anyone knows of where I can get this etc, I'd be extremely grateful! Thank you kindly x
Thank you China, unfortunately those are silver plated x
I apologize should have been more diligent, would be that difficult to make.
Last edited by china; 18-12-2017 at 12:33 PM.
The wonders of the internet will often fail you if looking for something specialised.
Making them yourself would be more tedious, but doable if it is only a few pairs. You need to take the thickness of the ribbon into account, and make sure that the teeth are alternating, so as to close neatly.
My remedy is to draw it to scale on squared paper, reduce it to the required size on my copier and then use it as a stick on label for piercing.
For better symmetry they can be made in a double length strip and cut in half after scoring and bending. Dennis.
Bookmarks